Silicon Laboratories Si53108-EVB User Manual
Silicon Laboratories Si53108-EVB User Manual

Silicon Laboratories Si53108-EVB User Manual

Advertisement

Quick Links

Si53108 E
VALUATION

Description

The Si53108-EVB can be used to evaluate the Si53108-
A01AGM, an 8-output PCIe Gen1/2/3 buffer that can
operate in either fanout or zero delay mode.
Rev. 0.1
B
OARD

Features

Copyright © 2014 by Silicon Laboratories
S i 5 3 1 0 8 - E V B
U
'
G
SER
S
UIDE
10-inch traces to evaluate signal integrity
The signal traces of the input and outputs have a
single-ended impedance of 50 ohms, and differential
impedance of 100 ohms.
The series resistance on the outputs are set to
match to this impedance design.
DC pin controls per data sheet specification.
Ability to measure input to output propagation delay.
Ability to measure PCIe clock jitter.
Ability to program features of Si53108-A01AGM via
2
I
C interface.
Si53108-EVB

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Si53108-EVB and is the answer not in the manual?

Questions and answers

Summary of Contents for Silicon Laboratories Si53108-EVB

  • Page 1 VALUATION OARD UIDE Description Features The Si53108-EVB can be used to evaluate the Si53108-  10-inch traces to evaluate signal integrity A01AGM, an 8-output PCIe Gen1/2/3 buffer that can  The signal traces of the input and outputs have a operate in either fanout or zero delay mode.
  • Page 2 Si53108-EVB 1. Schematics     Figure 1. Schematic 1 Rev. 0.1...
  • Page 3 Si53108-EVB Figure 2. Schematic 2 Rev. 0.1...
  • Page 4 Si53108-EVB Figure 3. Schematic 3 Rev. 0.1...
  • Page 5: Quick Start Guide

    Si53108-EVB 2. Input and Power Supply Sequencing The Si53108-A01AGM should be powered up with supply at both the VDD and VDD_IO nodes (at the jumpers available on the EVB). A 100MHz or 133MHz HCSL input clock should be applied to pins 8 and 9. There is no internal or on-board resistive termination, therefore HCSL termination needs to be provided at the input if needed by the driver.
  • Page 6 Si53108-EVB 5. Bill of Materials   Rev. 0.1...
  • Page 7 The products must not be used within any Life Support System without the specific written consent of Silicon Laboratories. A "Life Support System" is any product or system intended to support or sustain life and/or health, which, if it fails, can be reasonably expected to result in significant personal injury or death.

Table of Contents