General Information; Safety Instructions - Martin M2GO HD Service Manual

Service manual

General information

This service manual contains information about how to
service M2GO HD.

Safety instructions

Before you carry out service work, read this document.
Installation and service work must comply with local
regulations and accepted codes of good practice.
Observe the safety instructions in the user manual for
the product.
This product is for professional use only. It is not for
household use. It presents risks of lethal or severe
injury due to electric shock. Read this service manual
before powering on or installing the M2GO HD
controller, follow the safety precautions listed below
and observe all warnings in this manual and printed on
the product.
If you have questions about how to operate the product
safely, please contact your Martin™ by Harman
supplier or call the Martin 24-hour service hotline at
+45-8740-0000, or in the USA at +1-888-832-4180.
Warning
This product is for indoor use only.
Warning
This is a product according to
Class A. In a domestic environment
this product may cause radio
interference in which case the user
may be required to take adequate
measures.
• Ensure that the power supply is electrically
grounded (earthed). Do not use ground lift
adapters.
• Only use a source of AC power that complies with
local building and electrical codes and that has
both overload and ground-fault protection.
• Only use the provided AC power supply and
power cords and use the correct connector for the
country of operation. Use of the factory provided
power cable is mandatory for operation in the US
and Canada.
• Disconnect the product from power immediately
if the power supply or cable or any cover or
component is wet or not in perfect condition. Do
not reconnect to power until the damaged item
has been repaired or replaced.
• Do not expose the product to rain or moisture.
M1 HD - Revision A, 05-16-2017
Figure 1: Safety instructions
3 of 13