B1SD1-TF Motherboard User Manual
VGA Enable
P1-JPG1 allows the user to enable the on-
board VGA connector. The default setting is
pins 1-2 to enable the connection. See the
table on the right for jumper settings.
Watch Dog Timer Enable
Watch Dog (P1-JWD1) is a system monitor
that can be used to reboot the system when
a software application hangs. Close pins 1-2
to reset the system if an application hangs.
Close pins 2-3 to generate a non-maskable
interrupt signal for the application that hangs.
See the table on the right for jumper settings.
Watch Dog must also be enabled in the BIOS.
MAC CODE
MAC CODE
BAR CODE
P1-JBR1
P1-JPME1
P1-JPME2
B
CPU1
AST
2400
2-14
Pin #
1-2
2-3
Pin #
1-2
2-3
Open
A. P1-JPG1 VGA Enable
B. P1-JWD1 Watch Dog
A
VGA Enable
Jumper Settings
Definition
Enabled (Default)
Disabled
Watch Dog
Jumper Settings
Definition
Reset (Default)
NMI
Disabled