Rear Panel - Idis HE-1101 User Manual

3 Factory Reset Switch
Use to return all settings to the original factory settings. Connect the power and poke a straightened paperclip into
the factory reset switch hole. Hold the reset switch until the encoder's internal buzzer sounds twice. Release the
reset switch, and all of the encoder's settings are now at the original settings it had when it left the factory.
Factory Reset during system booting: All of the encoder's settings are now at the original settings it had when
it left the factory.
Factory Reset during system operating: The other settings except for protocol and system log are now at the
original settings it had when it left the factory.
Factory Reset via the IDIS Discovery program: The other settings except for protocol, system log and network
settings are now at the original settings it had when it left the factory.
Factory Reset via the IDIS Discovery program(including network settings) : The other settings except for
protocol and system log are now at the original settings it had when it left the factory.

Rear Panel

1
2
1
DC12V In
5
HDMI In
1 DC12V In
Connect the two wires of the power adapter to these ports. Be careful not to cross the DC12V and ground (GND)
wires. Booting will commence once connected to a power supply.
2 Network + PoE Power In
Connect a Cat5e cable with an RJ-45 jack. The video encoder is capable of connecting to networks via an Ethernet
connector and also receives power through the LAN cable from the NVR and switch hub supporting the PoE
function.
3 USB-B
Connect to an USB port to remotely control device such as PC, POS and NVR, etc (keybaord/mouse method).
When connecting to a device using Windows Operating System, do not remove the cable until the download of the
driver software is complete.
Remote control function does not work with DirectIP protocol.
4 Audio In/Out
Upper 3.5mm stereo input and lower loop output (only the left side channel transmitts over the network).
When connecting a 3.5mm mono cable to the upper 3.5mm stereo input, the lower loop output may not work normally.
4
3
5
2
Network + PoE Power In
6
HDMI Out
7
6
3
USB Port
7
VGA In
Part 1 - Introduction
8
4
Audio In/Out
8
VGA Out
11