Idis HE-1101 User Manual page 21

Use HTTPS: Select this option to apply https protocol-
based security on IDIS Web.
Use UPnP: If the encoder is connected to the network
via an IP router (or NAT), select this option to connect
to the encoder without setting up port forwarding.
The IP router (or NAT) must be enabled with UPnP in
order for this feature to function properly. For more
information enabling UPnP on your IP router (or NAT),
refer to the IP router or NAT's operation manual.
Click Check to test the current port settings.
A confirmation message will appear if all the
selected ports are available for use. If not, a list of
recommended port numbers will be shown.
Click Apply to use the recommended port numbers.
In a WAN environment, it is recommended that you
use the UPnP function if you record video by using
the FEN function or FEN connection is not smooth.
Otherwise, monitoring or recording might not be
smooth depending on the network environment.
Each port number must be unique.
It is not allowed to use the same port number for
more than one function.
You can connect to the encoder using a media
player that supports RTSP service and monitor
its video feed. If the encoder is connected to the
network via an IP router (or NAT) or is behind
a firewall, you must open the ports. (All ports if
using UDP protocol and RTSP ports if using TCP
protocol) This feature may not be supported by al
media player. In addition, video display on certain
media players may not be smooth depending on
the network status, video streaming compression
method used, and/or the resolution setting.
Connection methods are as follows:
– Via PC: Launch the media player (such as VLC)
and then enter rtsp://ID:Password@IP Address:
RTSP Port Number/trackID='Stream Number'
(Stream Number: 1 if Primary, 2 if Secondary, and
3 if Tertiary). (e.g.: rtsp://admin:@10.0.152.35:554/
trackID=1 (User: admin, Password: None, Encoder
IP Address: 10.0.152.35, RTSP Port Number: 554,
Stream: Primary))
Port numbers of the remote program must be
updated whenever the encoder's port numbers are
changed.
ONVIF protocol may not function if using HTTPS.
Part2 - Remote Setup
21