Rear Panel - Idis DE-1104 Operation Manual

Rear Panel

2
1
RS485
1
DC12V In
5
1 RS485
Connect a PTZ camera. Connect the camera's TX+/RX+ and TX–/RX– to the encoder's + and –.
For more information on RS485 connections, refer to the PTZ camera's manufacturer's user's manual.
2 Audio In
Connect to an audio source.
3 Video In
Connect coaxial cables from the video sources.
4 Network + PoE Power In
Connect a Cat5e cable with an RJ-45 jack. The video encoder is capable of connecting to networks via an Ethernet connector
and also receives power (DC48V) from the NVR.
5 DC12V In
Connect the two wires of the power adapter to these ports. Be careful not to cross the DC12V and ground (GND) wires. Booting
will commence once connected to a power supply.
• The network connector is not designed to be connected directly with cable or wire intended for outdoor use.
• Press down on the button and insert the cable into the opening when you connect the RS485 and power connectors.
Release the button and then pull on the cable slightly to ensure it is held securely in place. To disconnect the cable, press
down on the button again and pull the cable out.
• Ground the power port's ground terminal before use.
• Organize the power cable so that it will not cause people to trip over or become damaged from chairs, cabinets, desks,
and other objects in the vicinity. Do not run the power cable underneath a rug or carpet.
• Do not connect multiple devices to a single power outlet.
10
Audio In
2
3
Video In
3
4 5
Network + PoE Power In
4