Table of Contents
Advertisement
Reset
To reset the Ovation FD-205WW to the factory default settings:
1.
Go to the SETTING main level.
2.
Select the RESET programming level and then the display becomes blank.
3.
Enter the passcode as described in Passcode.
4.
"OK" appears on the display when finished.
Zoom - Options Control
The Ovation FD-205WW offers three zoom options during the operation of the OVATION FD-165WW. To
select from these option, do the following.
1.
Go to the SETTING main level.
2.
Select the ZOOM programming level.
3.
Choose from the following options:
a.
Select BASE for the default zoom position (full movement).
b.
Select POS1 for the position 1 zoom range.
c.
Select POS2 for the position 2 zoom range.
Setting Zoom Ranges
These settings allow you to select the zoom ranges for POS1 and POS2 during menu control of the zoom.
1.
Go to the CALIBRATION main level.
2.
Enter the passcode as described in Passcode.
3.
Go to the CALZ programming level.
4.
Select POSE1 (position 1) or POSE2 (position 2).
5.
Select the desired maximum for the zoom 000–255 (0–100%).
6.
Repeat to select the other position setting.
Resetting the Zoom Motor
To reset the zoom motor, do the following.
1.
Go to the MOTOR main level.
2.
Select YES.
Note: Selecting NO does not reset the zoom's motor.
Zoom - Menu Control
To adjust the beam of the Ovation FD-205WW, select the zoom setting as follows:
1.
Go to the STATIC main level.
2.
Select ZOOM.
3.
Choose the desired zoom setting 000–100.
Zoom - Manual Control
Manually adjust the zoom by using the zoom adjustment knob, as follows.
1.
Press the zoom adjustment knob above the display twice.
2.
Select the desired zoom setting 000–100 by turning the knob clockwise (value increases) or
counter-clockwise (value decreases)..
•
When using the zoom adjustment knob, the lowest zoom value stops at 000 and
the highest zoom value stops at 100.
•
During manual zoom control, you can also use <UP> or <DOWN>, which will
cycle through all the zoom values.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the Ovation FD-
205WW.
1.
Go to the SETTING main level.
2.
Select the PWM programming level.
3.
Choose a PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Page 16 of 22
Ovation FD-205WW User Manual Rev. 1
O
PERATION
Advertisement
Table of Contents
