Safety Cable Use; Pan And Tilt Adjustments; Pan Adjustment; Tilt Adjustment - Philips SELECON PLPROFILE4 MKII Installation And User Manual

PLPROFILE4 MKII LED Luminaires

Safety Cable Use

The supplied safety cable MUST always be used when rigging luminaires on bars, truss, etc. (as shown in Figure 4).
FOR LUMINAIRE, the supplied safety cable is recommended for all hanging installation and may be required by
national and local codes. Loop safety cable through luminaire yoke assembly as shown and attach to structure. FOR
LENS TUBE, attach a safety cable (sold separately) to lens tube anchor point and to yoke assembly. You should
always consult and follow all local and national codes and regulations for mounting and installation of luminaire.
WARNING! If your luminaire is equipment with the eyelet as indicated in Figure 4, DO NOT attach safety cable to
this eyelet on luminaire body. This eyelet feature was included for another purpose other than the safety cable and
will be removed from future production models.

6. Pan and Tilt Adjustments

Pan Adjustment

The pan adjustment of a PLPROFILE4 MKII LED Luminaire is achieved by loosening the yoke bolt of the securing
clamp attached to the luminaire's yoke assembly. Loosen the bolt, set the luminaire to the desired position and re-
tighten.

Tilt Adjustment

PLPROFILE4 MKII LED Luminaires offer variable tilt settings. The unit can be set at a specific angle (in relation to
its mounting position) or at an angle between 0 to 90 degrees. When the yoke is in the position shown in Figure 4,
you have full range access to shutters the gate etc. If you flip the yoke over some access is reduced but the over all
volume the luminaire takes up is reduced. This is particularly useful in tightly hung lighting positions or in theatres
with low grids.
Safety Cable
(supplied with
luminaire)
Safety Cable
Anchor Point
Yoke Assembly
To adjust and set tilt angle of the luminaire:
Step 1. Mount luminaire in desired location (see
Step 2. Loosen, but do not remove, T-Handle Tilt Locks at base of yoke assembly as shown in Figure 4.
Step 3. Position luminaire to desired tilt position.
Step 4. Retighten T-Handle Tilt Locks to set position.
SAFETY CABLE: FOR LUMINAIRE, the supplied safety cable is recommended for
all hanging installation and may be required by national and local codes. Loop
safety cable through luminaire safety cable anchor point. FOR LENS TUBE, attach
a safety cable (sold separately) to lens tube anchor point and to yoke assembly.
Figure 4: Luminaire Tilt Adjustment
"Mounting" on page 10
Installation & User's Manual
Cooling Vents (see note below)
Safety Cable
(sold separately)
T-Handle Tilt Lock
(one on each side)
Sliding Yoke Assembly
NOTE: To allow for proper cooling, make
sure luminaire head is orientated as shown
(with cooling vents pointed upwards).
for more information).
Pan and Tilt Adjustments
11