Cleaning And Care; Special Cleaning And Care Instructions - Philips SELECON PLPROFILE4 MKII Installation And User Manual

Installation & User's Manual

CLEANING AND CARE

WARNING! All cleaning should be performed with power completely removed from the luminaire. Never remove
protective covers when luminaire is powered. Wear appropriate protective eye wear and gloves when cleaning the
fixture. All service and maintenance, other than described herein, should be performed by a qualified technician or
Authorized Service Center.

1. Special Cleaning and Care Instructions

Being a solid-state fixture, and unlike most fixtures, the PLPROFILE4 MKII LED Luminaire requires very little
routine maintenance by the user. This section covers portions of the luminaire that can be removed for cleaning.
The PLPROFILE4 MKII LED Luminaire requires special care when it comes to cleaning front lens assembly.
Additional care needs to be taken with the plastic components because they are much easier to scratch or damage than
glass.
The following is a list of cleaning materials required to care for your PLPROFILE4 MKII LED Luminaire:
• Lint free lens tissue
• Lint or powder free gloves
• Reagent grade isopropyl alcohol*
• A mild soap solution.
Note: *Reagent grade isopropyl alcohol is good to use on the PLPROFILE4 MKII LED Luminaire plastic optics
with anti-reflection coatings.
If the lens is still dirty after using isopropyl alcohol, for instance if fingerprints or oil is just redistributed and not
cleaned off the optic, then a mild soap and water solution can be used to gently wash the lens. Repeat the cleaning
with isopropyl alcohol to eliminate streaks and soap residue.
WARNING! Under no circumstances should ammonia-based cleaners, acetone, or other harsh solvents be used on or
near the PLPROFILE4 MKII LED Luminaire. These types of cleaners or solvents can permanently damage the optics
or housings of the fixture.
If you have any questions regarding the use or care of your PLPROFILE4 MKII LED Luminaire, please contact
Philips Selecon technical support or your local Authorized Dealer.
2. Lens Cleaning
Front Lens (Exterior)
To clean the exterior front lens:
Step 1. Turn off luminaire and allow to cool completely.
Step 2. Apply a small amount of reagent grade isopropyl alcohol to lint-free lens tissue.
Step 3. Wipe all debris, dirt, fingerprints, etc. from lens.
Step 4. Using a second lint-free lens tissue, wipe off any alcohol residue.
Front Lens (Interior)
To clean the interior of front lens:
Step 1. Turn off luminaire and allow to cool completely.
Step 2. Place luminaire on a flat, clean surface. Be careful not to scratch or damage luminaire.
3 6
CLEANING AND CARE
PLPROFILE4 MKII LED Luminaires