Display Related; Holding The Level Meter Peaks; Checking The Remaining Disk Capacity - Roland VXpanded VS-880 Owner's Manual

Display related

Holding the level meter peaks

When the bar display (p.114) is the level meter, you can
now cause the maximum volume value (peak) to remain (be
held) in the display.
CONDITION MARKER#
INPUT TRACK
1. Press [SYSTEM] several times until "SYS System
PRM?" appears.
2. Press [YES].
3. Press PARAMETER [
play indicates "SYS PeakHoldSw=".
CONDITION MARKER#
INPUT TRACK
4. Rotate the TIME/VALUE dial.
PeakHoldSw (Peak hold switch)
When Pre Level or Post Level is displayed in the bar dis-
play, you can specify whether the peaks will be held.
OFF: Peaks will not be held (same as Ver.1).
ON: Peaks will be held.
5. Press [PLAY(DISPLAY)].
You will return to Play condition.
To reset the peak display, press [PLAY(DISPLAY)].
Checking the remaining disk
capacity
The REMAINING TIME column indicates the approximate
time (capacity) remaining for recording in the current song.
You can now specify the type of this display.
1. Press [SYSTEM] several times until the "SYS System
PRM?" display appears.
2. Press [YES].
3. Press PARAMETER [
RemainDsp=" display appears.
4. Rotate the TIME/VALUE dial.
TIME TIME
dB
0
4
1 1 2 2
24
48
AUX MASTER
] several times until the dis-
TIME TIME
dB
0
4
1 1 2 2
24
48
AUX MASTER
] several times until the "SYS
Chapter 1 Trying out the expanded functions
RemainDsp (Remaining display)
Specify how the remaining disk capacity will be displayed.
Time: Displayed as recording time (minutes/sec-
onds) (same as Ver.1).
CapaMB: Displayed as actual capacity (MB).
Capa%: Displayed as percentage (%) of capacity of the
entire disk.
Displayed as the number of events used for
Event:
recording.
5. Press [PLAY(DISPLAY)].
You will return to Play condition.
37