Roland VXpanded VS-880 Owner's Manual page 107

Digital studio workstation
Hide thumbs Also See for VXpanded VS-880:
Table of Contents

Advertisement

EFFECT 1 Send (Effect 1 send level)
Specify the volume level (0Ð127) of the signal that is sent to the EFFECT 1 buss. The default setting
is 100.
9. Press PARAMETER [
The display will indicate ÒCH1 EFFECT1 Pan=Ó.
10. Adjust the panning of the signal that will be input to effect 1. Rotate the TIME/VALUE dial.
EFFECT 1 Pan (Effect 1 pan)
For channels on which Channel Link is ÒOff,Ó this sets the panning (L63Ð0ÐR63) of the stereo signal
which is output to the EFFECT 1 buss. ÒL63Ó is far left, and ÒR63Ó is far right.
For channels on which Channel Link is ÒOn,Ó this sets the left/right volume balance (L63Ð0ÐR63)
of the stereo signal from the paired channels which is output to the EFFECT 1 buss.
The default value is Ò0Ó (center).
11. Repeat steps 2–10 to make settings for channels 2–6 in the same way.
12. Press channel 7 [CH EDIT].
13. Hold down [SHIFT] and press channel 1 [EFFECT-1(Input/BUSS)].
14. Rotate the TIME/VALUE dial. For this example, select "MIX-L" so that the signal of the MIX bus
will be recorded.
Input (input select)
This selects the input source of each channel. If Channel Link is on, stereo sources can be selected.
When Channel Link is off:
When Channel Link is on:
CONDITION MARKER#
INPUT TRACK
15. Press channel 8 [CH EDIT].
16. Repeat steps 13, 14 to make settings for channel 8 in the same way. However in step 16,
select "MIX-R" so that the R side of the MIX buss will be recorded.
17. Press [EDIT(SOLO)] several times until "MST EFF1 RTN to=" appears.
18. Rotate the TIME/VALUE dial. For this example, select "MIX".
EFF1 RTN to (Effect 1 return to)
Select the output destination of effect 1. The busses that can be selected will depend on the current
mixer mode.
When in INPUT TRACK mode
MIX:
the MIX buss (stereo)
AUX: the AUX buss (stereo)
19. Press PARAMETER [
The display will indicate ÒEFF1 RTN Lev=Ó.
20. Adjust the output level of effect 1. Rotate the TIME/VALUE dial.
EFF1 RTN Lev (Effect 1 return level)
Set the output level (0Ð127) of effect 1.
].
INPUT 1Ð4, DIGITAL-L, DIGITAL-R, MIX-L, MIX-R, AUX-A,
AUX-B
INPUT-12, INPUT 34, DIGITAL, MIX, AUX-AB
TIME
TIME
dB
0
4
1 1 2 2
24
48
AUX
MASTER
].
Chapter 8 Using the internal effects
107

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents