Roland Edirol UA-25 Owner's Manual page 16

Driver installation and settings (Windows)
7
Find the included CD-ROM.
Insert the CD-ROM into your computer's CD-ROM drive.
8
From the Windows start menu, choose "Run..."
The "Run" dialog box will appear.
9
Input the name into the dialog box as shown, and click
[OK].
fig.win-run
(Drive name): \Driver\XP2k\setup.exe
* The drive name is "D:" in the example shown here, but this
may be different on your system. Specify the drive name for
your CD-ROM drive.
The SetupInf dialog box will appear.
You are now ready to install the driver.
10
Set the UA-25's ADVANCE (mode select) switch to the
ON position.
11
Use the USB cable to connect the UA-25 to your
computer.
Near the task bar, your computer will indicate "Found
New Hardware". Please wait.
12
The Found New Hardware Wizard will appear.
Select "Install from a list or specific location
(Advanced)", and click [Next].
13
The screen will indicate "Please choose your search
and installation options".
Select "Don't search. I will choose the driver to install",
and click [Next].
14
Make sure that the "Model" field indicates "EDIROL UA-
25", and click [Next]. Driver installation will begin.
16
If the screen indicates
"Windows can perform the
same action each time you
insert a disk or connect a
device with this kind of file,"
click [Cancel].
Checking the name of your
drive.
From the start menu, choose
My Computer. In the window
that appears, verify the name
of the CD-ROM drive into
which you inserted the CD-
ROM in step 7.
The (D:) or (E:) displayed by
the CD-ROM drive icon
the drive name.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting the USB cable is
required before the unit will
operate normally.
is