Mac Os 9 Users - Roland Edirol UA-25 Owner's Manual

Driver installation and settings (Macintosh)

Mac OS 9 users

Installing the UA-25driver
Use either OMS or FreeMIDI as the MIDI driver.
The included UA-25 driver is an add-on module for using
the UA-25 with OMS or FreeMIDI.
* Either OMS or FreeMIDI must be installed in your
Macintosh, as appropriate for the sequencer software you are
using.
If you install OMS or FreeMIDI after installing the UA-25
driver, you must install the UA-25 driver once again.
If a UA-25 is already connected to your Macintosh when you install the driver, a
message like the following will appear when the Macintosh is started up. Perform the
steps described below as appropriate for the message that is displayed.
If the screen indicates:
"Software needed for the USB device "UA-25" is not available. Would you like to
look for the software on the Internet?"
→ click [Cancel].
If the screen indicates:
"The software needed to use the USB device "UA-25" cannot be found. Please
refer to the device documentation to install the necessary software".
→ click [OK].
Use the following procedure to install the UA-25 driver.
Disconnect the UA-25 from the Macintosh before you
perform the installation.
1
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure
to exit this as well.
2
Prepare the CD-ROM.Insert the CD-ROM into the CD-
ROM drive.
3
Double-click the UA-25 Driver-E Installer icon (found in
the Driver E (Mac OS 9) folder of the CD-ROM) to start
up the installer.
4
Verify the Install Location, and click [Install].
36
OMS can be found in the OMS
2.3.8 E folder within the OMS
(Mac OS 9) folder of the CD-
ROM. If you would like to
know more about OMS, refer
to OMS_2.3_Mac.pdf which
can be found in the same
folder.