Parameter List; Patch Parameters - Roland RS-50 Owner's Manual

Parameter list

Patch parameters

Patches
Patch Common parameters (p. 45)
Parameters
Name Patch Name
Category
Key Mode
Patch Level
Tone Balance
Split Point
Split Arp Split Arpeggio
Solo Switch
ModulationDst Modulation Destination
PitchBend Dst Pitch Bend Destination
Modify Dest Modify Destination
ExpressionDst Expression Destination
Active Exp Sw Active Expression Switch
Patch Tone parameters (p. 46)
Parameters
No. Original Tone Number
Tone Pan
MFX Switch Multi-Effects Switch
Chorus Send Lvl Chorus Send Level
Reverb Send Lvl Reverb Send Level
Coarse Tune
Fine Tune
Portamento Sw Portamento Switch
Portamento Time
Velo Sens Depth Velocity Sensitivity Depth
Velo Sens Ofs Velocity Sensitivity Offset
Pitch Bend Range
Filter LFO Filter LFO Switch
LFO Rate
LFO Depth
LFO Delay
Cutoff Freq Cutoff Frequency
Resonance
Attack Time
Decay Time
Release Time
Patch Effects parameters
* The same parameters are also provided for Rhythm sets.
Parameters
Multi-effects group
Type Multi-effects Type
--- Multi-effects Parameters
Send Lvl to Cho Multi-effect send level to chorus
Send Lvl to Rev Multi-effect send level to reverb
Ctrl 1 Multi-effects Control 1
Ctrl 2 Multi-effects Control 2
Chorus effects group
Type Chorus type
Pre-LPF Chorus pre-low pass filter
Level Chorus Level
106
Value
space, A–Z, a–z, 0–9, ! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ ¥ ] ^ _
` { | }
* Refer to "Selecting a patch by category" (p. 20).
SINGLE, SPLIT, DUAL
0–127
-64 (LOWER) – +63 (UPPER)
A0–C8
UPPER, LOWER, BOTH
OFF, ON, UPPER, LOWER
UPPER, LOWER, BOTH
UPPER, LOWER, BOTH
UPPER, LOWER, BOTH
* This is linked with the panel's [DESTINATION TONE] setting.
UPPER, LOWER, BOTH
OFF, ON
Value
0001–0640
L64–63R
BYPASS, ON
0–127
0–127
-48– +48
-50– +50
OFF, ON
0–127
-64– +63
-64– +63
0–24
OFF(PCH), ON(FLT)
-64– +63
-64– +63
-64– +63
-64– +63
-64– +63
-64– +63
-64– +63
-64– +63
Value
00 THROUGH–47 FBK RIPPER
The number of parameters varies depending on the Multi-effects
Type. Refer to "Setting multi-effects parameters" (p. 68).
0–127
0–127
Refer to "Setting multi-effects parameters" (p. 68).
Refer to "Setting multi-effects parameters" (p. 68).
CHORUS1, CHORUS2, CHORUS3, CHORUS4, FEEDBACK
CHORUS, FLANGER, SHORT DELAY, SHORT DELAY(FB)
0–7
0–127