Chorus Parameter - Roland RD-700SX Owner's Manual

Effect/Parameter List

Chorus Parameter

The RD-700SX's Chorus effect unit can also be used as a stereo delay
unit.
0: OFF
Neither Chorus or Delay is used.
1: CHORUS
Parameter Value
Filter Type OFF, LPF,
HPF
Cutoff Freq 200–8000 Hz
Pre Delay 0.0–100.0 ms
Rate Mode Hz, note
Rate (Hz) 0.05–10.00
Hz
note (*)
Rate ( )
Depth 0–127
Phase 0–180 deg
Feedback 0–127
2: DELAY
Parameter Value
Delay L Mode ms, note
Delay L (ms) 0–1000 ms
note (*)
Delay L ( )
Delay R Mode ms, note
Delay R (ms) 0–1000 ms
note (*)
Delay R ( )
Delay C Mode ms, note
Delay C (ms) 0–1000 ms
note (*)
Delay C ( )
Center Feedbak -98–+98 %
HF Damp 200–8000
Hz,
BYPASS
Left Level 0–127
Right Level 0–127
Center Level 0–127
144
Description
Type of filter
OFF: no filter is used
LPF: cuts the frequency range above the
Cutoff Freq
HPF: cuts the frequency range below
the Cutoff Freq
Basic frequency of the filter
Adjusts the delay time from the direct
sound until the chorus sound is heard.
When this is set to "note," the effect is
synchronized with the tempo.
Frequency of modulation (Hz)
Frequency of modulation (note)
Depth of modulation
Spatial spread of the sound
Adjusts the amount of the chorus sound
that is fed back into the effect.
Description
When this is set to "note," the effect is
synchronized with the tempo.
Adjusts the time until the delay sound is
heard. (Hz)
Adjusts the time until the delay sound is
heard. (note)
Settings of the Delay R
The parameters are the same as for the
Delay L.
Settings of the Delay C
The parameters are the same as for the
Delay L.
Adjusts the proportion of the delay sound
that is fed back into the effect. Negative (-)
settings will invert the phase.
Adjusts the frequency above which sound
fed back to the effect will be cut. If you do
not want to cut the high frequencies, set
this parameter to BYPASS.
Volume of each delay sound
Volume of each delay sound
Volume of each delay sound
3: GM2 CHORUS
Parameter Value
Pre-LPF 0–7
Level 0–127
Feedback 0–127
Delay 0–127
Rate 0–127
Depth 0–127
Send To 0–127
Reverb
note :
(*)
fig.MFX-note2e
(Sixty-fourth-note triplet), (Sixty-fourth note),
(Thirty-second note), (Sixteenth-note triplet),
(Sixteenth note), (Eighth-note triplet),
(Eighth note), (Quarter-note triplet),
(Quarter note), (Half-note triplet),
(Whole-note triplet), (Dotted half note),
(Double-note triplet), (Dotted whole note),
Description
Cuts the high frequency range of the
sound coming into the chorus.
Higher values will cut more of the high
frequencies.
Volume of the chorus sound
Adjusts the amount of the chorus sound
that is fed back into the effect.
Adjusts the delay time from the direct
sound until the chorus sound is heard.
Frequency of modulation
Depth of modulation
Adjusts the amount of chorus sound that
will be sent to the reverb.
(Thirty-second-note triplet),
(Dotted thirty-second note),
(Dotted sixteenth note),
(Dotted eighth note),
(Dotted quarter note), (Half note),
(Whole note),
(Double note)