Changing Sound Characteristics (Tone Modify); Restore The Settings To Initial Conditions (Initialize); Making Detailed Settings For The E.piano Tones (E.piano Edit); Making The Settings - Roland RD-700SX Owner's Manual

Making Detailed Settings for the ONE TOUCH Tones
Changing Sound Characteristics
(Tone Modify)
You can make changes in tones by adjusting the settings of the
elements.
Decay Time Offset:
The time it is to take following the attack for the volume to decrease.
Cutoff Offset:
Adjusts how much the filter is opened.
Release Time Offset:
The time it takes after the key is released for a sound to become
inaudible.
Parameter Value
Decay Time -64–+63
(Offset)
Cutoff
(Offset)
Release
Time
(Offset)
With certain tones, the effect may be difficult to distinguish.
Restore the settings to initial
conditions (Initialize)
This restores the One Touch E. Piano settings to their initial
conditions.
1. In Step 3 of the Piano Edit settings instructions
(p. 73), select "5. Initialize" and press [ENTER].
To cancel the Initialize, press [EXIT].
2. Press [ENTER].
The confirmation message appears.
3. Press [ENTER] once again.
The ONE TOUCH [PIANO] tones are initialized.
76
Description
The time it takes for the volume to
fall increases as the value is raised;
lowering the value decreases the
decay.
Higher values brighten the sound;
lower values make the sound seem
darker.
Higher values produce longer decay;
set lower values for a clear-cut
sound.
Making Detailed Settings
for the E.Piano Tones
(E.Piano Edit)
You can make more detailed settings to fashion just the Tones you
want using the E.piano Tone selected by pressing ONE TOUCH
[E.PIANO] (p. 32).
This function is called "E.Piano Edit."
The settings made in E.Piano Edit are stored to ONE TOUCH
[E.PIANO].
When ONE TOUCH [E.PIANO] is pressed, all settings other
than the E.Piano Edit settings are switched to their status at the
time the RD-700SX's power was turned on. Store any
arrangements of settings that you want to keep in Setup (p. 58).

Making the settings

1. Press [F1] in the ONE TOUCH [E.PIANO] screen to
select the type you want to set.
2. Press [F2].
fig.04-g07-1
3. Press CURSOR [
]/[
press CURSOR [
the parameter to be set.
4. Press [INC]/[DEC] to set the value.
5. If you want to save the setting, press [F1 (WRITE)].
The confirmation message appears. Press [F1 (WRITE)] to save
the settings. If you want to cancel, press [EXIT].
6. When you finish making settings, press [EXIT].
You are returned to the ONE TOUCH [E.PIANO] screen.
] to switch screens, and
]/[ ] to move the cursor to