Turning The Controllers In Each Zone On And Off; Making Tone Settings (Tone Info); How To Make Settings - Roland RD-700SX Owner's Manual

Making Detailed Settings for Tones
Turning the Controllers in Each
Zone On and Off
These settings determine whether the pedals connected to each
PEDAL jack (DaMPER, FC1, FC2), the Modulation lever, the Bender,
and the Slides are used to control the Parts (ON), or not (OFF).
Parameter Description
Dp Damper pedal
F1 Pedal connected to the FC1 jack
F2 Pedal connected to the FC2 jack
PB Pitch Bender
Md Modulation Lever
UP1 Control Slider (UP1)
UP2 Control Slider (UP2)
LW1 Control Slider (LW1)
LW2 Control Slider (LW2)
70
Making Tone Settings
(Tone Info)
You can make more detailed settings to the tones assigned to each of
the Internal parts.
Value
In certain selected Tones, there may be parameters that cannot
ON, OFF
be changed.

How to Make Settings

1. In the Tone screen, press [F1(Tone Info)].
The [F1] is lit, and the Tone Info screen appears.
fig.04-03g
2. Press CURSOR [
press CURSOR [
the parameter to be set.
fig.04-04g
3. Press [INC]/[DEC] to set the value.
4. When you finish making settings, press [F1],
extinguishing its indicator.
You are returned to the Tone screen.
The following parameters cannot be changed when the selected
tone is used as the Virtual Tonewheel tone.
• Mono/Poly
• Coarse Tune
• Fine Tune
• Portamento Switch
• Portamento Time
• Attack Time
• Release Time
• Cutoff
• Resonance
• Decay Time
]/[ ] to switch screens, and
]/[ ] to move the cursor to