Clevo M740J Service Manual page 42

Disassembly
Processor Installation Procedure
Figure 12
Processor 1. Insert the CPU
Installation
turn the release latch
2. Remove the sticker
3. Insert the heat sink
a. Insert the CPU.
b. Turn the release latch to-
4. Tighten screws
wards the lock symbol.
5. Replace the component bay cover and tighten the screws
c. Remove the sticker from
the heat sink and insert
the heat sink.
d. Tighten the screws.
A. CPU
D. Heat Sink
• 3 Screws
2 - 16 Removing and Installing the Processor
A
, pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE IT!), and
B
towards the lock symbol
(Figure 12c) from the heat sink.
C
as indicated in
D
- in the order indicated on the label
1 3
a.
A
b.
B
(Figure 12b).
Figure 12c.
.
(page 2 - 9).
c.
d.
C
D
M740J/M760J
C
D
M740JU/M760JU