Connecting To Other Devices; Connecting To Audio Equipment; Connecting Speakers To The Lx-10 And Outputting Sounds - Roland LX-10 Owner's Manual

Connecting to Other Devices

Connecting to Audio Equipment

You can connect audio devices to play the sound of the LX-10
through the speakers of your audio system, or to record your
performance on a tape recorder or other recording device.
Use phone plug audio cables (sold separately) to make
connections.
Before connecting audio cables to the bottom panel
NOTE
(the back edge of the LX-10's bottom), you'll need to
remove the rear board upper (p. 18).

Connecting Speakers to the LX-10 and Outputting Sounds

1.
Turn the volume all the way down on the LX-
10 and on the device you're about to
connect.
2.
Turn off the power to the LX-10 and
connected speakers.
3.
Use audio cables (sold separately) to make
the connection.
4.
Switch on the LX-10.
5.
Switch on the connected speakers.
6.
Adjust the volume level on the LX-10 and the
connected speakers.
When you play the LX-10's keyboard, the sound is played
from the connected speakers.
92
926a
* When connection cables with resistors are used, the
volume level of equipment connected to the input jacks
may be low. If this happens, use connection cables that
do not contain resistors.
* To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn off
the power on all devices before making any connections.
Output Jacks
Turning Off the Power
1.
2.
3.
Amplified Speakers,
Audio System, etc.
Input (Line In)
Turn the volume all the way down on the LX-
10 and on the connected speakers.
Turn off the connected speakers.
Turn off the LX-10.