Chapter 5: Chassis Setup and Maintenance
Chapter 5
Chassis Setup and Maintenance
5-1
Overview
This chapter covers the steps required to install components and perform
maintenance on the chassis. The only tool required is a Phillips screwdriver.
Review the warnings and precautions listed in the manual before setting up or
servicing this chassis. These include information in Appendix B: Warning Statements
for AC Systems and the warning/precautions listed in the setup instructions.
Control Panel
24 Hot-Swap Drive Bays
Figure 5-1. Front View
PCI Slots
Power Supplies
I/O Ports
SIOM Slot
Figure 5-2. Rear Chassis View, Four Nodes
5-1