Initial Setup; Select Language; Vessel Type; Select Type - Raymarine ST70 User's Reference Manual

8

Initial setup

Select language

< >
Use and
'Welcome' screen. When you are ready to proceed, press
Vessel Type menu.

Vessel Type

The Vessel Type menu enables you to automatically
apply the optimum instrument settings for your
vessel type. The options are:
• Race Sail
• Sail Cruiser
• Catamaran
• Workboat
• RIB
• Outboard Speed Boat
*Power Cruiser settings. Note that the Power Cruiser settings apply as follows:
• Power Cruiser 1 - capable of speeds up to 12 knots.
• Power Cruiser 2 - capable of speeds up to 30 knots.
• Power Cruiser 3 - capable of speeds greater than 30 knots.

Select type

< >
Use and
When you have chosen the vessel type, press
and Date values and the data Units considered most appropriate for the Language
and Vessel Type you chose, are then automatically applied to your ST70 system and
an automatic check of system parameters is carried out.

Autodetect results

When the automatic checks are complete, a Time &
Date summary page is displayed. This shows the
current values applied to your ST70 system.
Note:
If your instrument is not receiving GPS information,
time and date information are not available.
Time & Date
You can either change or accept the Date Format,
Time Format and Time Offset settings. You can:
• Select either dd/mm/yy or mm/dd/yy as the date format
• Select either 12-hour (am/pm) or 24-hour as the time format.
• Set the value of the time offset to give the required local time.
With the Time & Date summary page displayed, check the information, then press
ENTER
to display the Time & Date setup menu.
to select the required language, then press
• Inboard Speed Boat
• Power Cruiser 1*
• Power Cruiser 2*
• Power Cruiser 3*
• Sport Fishing
• Pro Fishing
to select the vessel type that most closely corresponds to your vessel.
ST70 Instrument User Reference Manual
ENTER
ENTER
Vessel Type
Inboard Speed Boat
Selecting vessel type helps us to
i
configure your system.
Press ENTER to select
ENTER
to confirm the choice. The Time
Time & Date
These are your current settings.
i
Press ENTER to continue
to display the
to display the
Time 11:01:03
Date 14/06/07
Time Offset -1 Hrs
Time Format 24-hour
Date Format dd/mm/yy