Changing How The Pedal Effects Are Applied; Changing How The Pedals Work - Roland FP-2 Owner's Manual

Changing How the Pedal
Effects Are Applied
When the pedal is pressed in Dual Play (p. 15) or Split Play
(p. 16), the pedal's effect is applied to both the Upper Tone
and the Lower Tone, but you can change the settings for the
tone to which the effect is applied.
Indication
U-L All enabled
-U- Applied only to the Upper Tone
Applied only to the Lower Tone
-L-
fig.04-03
■ How the Soft Pedal(FC2)
effects are applied
1.
Switch to Function mode (p. 38), and press the
[E.Piano] button.
2.
Press the [-] or [+] button to select how the pedal
effects are to be applied.
■ How the Sostenuto Pedal(FC1)
effects are applied
1.
Switch to Function mode (p. 38), and press the
[Organ] button.
2.
Press the [-] or [+] button to select how the pedal
effects are to be applied.
■ How the Damper Pedal effects
are applied
1.
Switch to Function mode (p. 38), then press the
[Guitar/Bass] button.
2.
Press the [-] or [+] button to select how the pedal
effects are to be applied.
Description
Chapter 4 Other Functions
Changing How the Pedals
Work
A pedal connected to the Soft(FC2) jack normally functions as
a soft pedal (p. 9). A pedal connected to the Sostenuto(FC1)
jack normally functions as a sostenuto pedal (p. 9).
It can also be set to function as an another works.
You can select from the following pedal functions.
* With certain sounds, the function may not work.
Indication
dnP Sets function to damper pedal.
(Damper)
SFt Sets function to soft pedal.
(Soft)
Stn Sets function to sostenuto pedal.
(Sostenuto)
Allows control of the volume. Connect a
separately available expression pedal
EPr
(EV-5).
(Expression)
* You cannot change volume level of session
partner.
Allows control the start/stop of Session
r.St
Partner by pressing the pedal, instead of
(Start/Stop)
pressing the buttons.
Allows control the on/off of leading bass
L.bS
function*. It is turned on while having
(Leading bass)
stepped on the pedal.
Effects can be switched on/off by pressing
EFF the pedal instead of pressing the [Effects]
(On/Off of button.
Effects) When effect type is rotary, you can control
the slow/fast of spinning.
b.uP Pitch rises by pressing the pedal.
(Bend Up)
b.dn Pitch lowers by pressing the pedal.
(Bend Down)
Mod Vivrato is added by pressing the pedal.
(Modulation)
* What is the leading bass function?
The function that sounds the lowest note of a fingered chord
as the bass tone is called "Leading Bass."
* Use only the specified expression pedal (EV-5; sold separately).
By connecting any other expression pedals, you risk causing
malfunction and/or damage to the unit.
* The function may not work properly if a pedal other than the
supplied pedal or expression pedal is used.
* Be sure to switch off the power to the unit before attempting to
disconnect or connect a pedal cord.
Description
39