Maytag MAH2400AW Technical Information page 5

Troubleshooting Procedures
To avoid risk of electrical shock, personal injury or death; disconnect power to washer before servicing, unless
testing requires power.
Test or Display
Press LED to
Fast Press Spin to
start test. Press
Time-
Start/Pause
Down /
during cycle to
Advance
advance.
to Next
Step
Press
Quick
Temperature
Service
and Soil Level
Cycle
Hold Quick Press Delay
Start and
Service Cycle
Chime together
Step
Press Delay
Start (then
LED/Switch individual
buttons to test)
Test
Rotate Cycle
Selector
clockwise, the
LED's around it
will be toggled.
Rotate counter
clockwise, the
7-segment
LED's toggle.
Press
Start/Pause
button inside
the "Rotary
Cycle Selector,
all of the LED's
around the
Rotary Cycle
Selector will be
toggled.
Board Press
IN
Temperature
Input
Test
Press
Board
Temperature
Output
and Extra
Test /
Rinse
System Check
Press Chime –
st
1 code
displays
Diagnostic
Code Display
(Initial)
June 2006
©2006 Maytag Services
!
Press LED to
Start Cancel
Press Spin
Press Power
Off (also exits
Service Mode)
Press Delay
Start and
Chime to
resume
Press Power
Off twice after
starting test
Press
Temperature
Press
Temperature
and Extra
Rinse
Press Chime
again
WARNING
Test or Display
All Diagnostic
Codes
Cycle Count
No. for
Diagnostic
Code
Clear All
Diagnostic
Codes
Display
Software
Version
Cycle Count
Quick Spin Test
While in Service Mode, press Delay Start and
Temperature keys to start a Quick Spin Test.
Quick Spin test steps are as follows:
1) Lock the door.
2) Spin clockwise and stop.
3) Spin counterclockwise and stop.
4) Spin counterclockwise, start Drain Pump and spin
to maximum RPM. Hold for 25 seconds.
5) Coast down, stop and turn 'OFF' Drain Pump.
6) Unlock Door after 60 seconds. Beeps once.
Hold Quick Spin Step
If the Start Pause key is pressed during the
Quick Spin test, the machine will hold at the
current speed for up to 10 minutes. At the end
of 10 minutes, the machine will resume and
finish the Quick Spin test. To cancel the Hold
and allow the Spin Test to continue, press the
Delay Start and Temperature keys.
5
Press LED to Press LED to
Start Cancel
Rotate Cycle N/A
Selector either
direction
Press and hold
Release
Start/Pause in Start/Pause
center of cycle (returns to
selector knob, diagnostic code
while diagnostic display)
code is
displayed
Press Delay
Start + Soil
Level together
while displaying
diagnostic
codes
Press Soil Press Soil
Level. Press 2 Level a 3
times for
displays with
only 2 character
positions.
Press Extra
Rinse
RPL 16023431
rd
time
16027174