Password; Program Password; Enter Password; Change Password - janitza Prophi Operating Instructions Manual

Reactive Power Controller

Password

The settings of Prophi
can be protected
against unintentional
change by a four digit
user password. This
denies the access to the menus:
- manual mode
- standard programming and
- expanded programming.
Prophi works in automatic mode and only the measured
values can be seen.
In delivery condition, no password ("0000") is pro-
grammed, the user has full access to all menus.
After programming a password, it is always requested
before accessing one of the locked menus. The pass-
word can be changed within the expanded program-
ming. If ("0000") is entered as a password, the user has
full access to all menus.
If a changed password is not known anymore,
m
the device has to be sent back to the manufactur-
ing work.

Program password

If no password was programmed so far, please proceed
as follows:
Scroll to expanded pro-
gramming by pressing
key 1. The symbol
"Prog" is flashing.
Confirm selection with
key 2.
The menu for program-
ming the fix stages ap-
pears.
Scroll to menu pass-
word by pressing key
3. Confirm selection
with key 1.
The first number of the
password is flashing.
Select the digit, which shall be changed, with key 2.
The selected number is flashing.
Change number with key 3.
If the password has been completed, confirm password
with key 1.
No digit is flashing now.
The new password is active.
= Key 1
Prog
Prog
Prog
Prog
= Key 2 = Key 3

Enter password

If the programming is protected by a password, you
must enter this password to have access to the locked
menus.
Press key 1. The first
digit is flashing.
Select the number,
which should be
changed with key 2.
The selected number flashes.
Change number with key 3.
If the password is completed, end input with key 2.
If the password was invalid, the request for a password
appears again.
If the password was
correct, you are in
menu "manual mode"
of the standard pro-
gramming.
Scroll to the required programming menus with key 1.
The programming menus are locked again automati-
cally, when no key was pressed over 60 seconds.

Change password

To enter a new password, please change to expanded
programming by using the old password, which has to
be entered first.
Confirm with key 1.
The first digit of the
password is flashing.
Now enter the old pass-
word.
Select the number to be changed by key 2, the selected
number is flashing.
Change the selected number with key 3.
If the password is completed, confirm with key 2.
If the password was invalid, the request for the pass-
word appears again.
If the password was correct, you are in menu "manual
mode" of the standard
programming.
Now you can overwrite
the password as de-
scribed under "pro-
gram password".
Entering the password "0000" releases the lock
m
of the programming menus.
Prog
Prog
Page 39