Terminals And Connectors - Canon WUX7000Z User Manual

Before Use

■ Terminals and Connectors

(2)
(1)
(1) LAN / HDBaseT port (P81, P83)
Receives HDBaseT input including digital video and audio signals.
Carries both video and audio signals across a single LAN cable (shielded
twisted pair).
This port can also be used to connect the projector to a network.
(2) AUDIO OUT terminal (P81)
Outputs the audio to external AV equipment. This outputs the audio signal that
corresponds to the projected image signal.
(3) AUDIO IN terminal (P81)
Receives audio input. Audio supplied to this terminal is played through the
internal speaker when you set [Audio in terminal select] to [Audio in] (P169).
(4) Terminal for wired remote control (P42)
This terminal is used to connect the optional remote control (RS-RC05) using a
cable.
(5) DisplayPort port (P79)
Receives DisplayPort input including digital video and audio signals.
Carries both video and audio signals across a single cable.
(6) HDMI terminal (P78)
Receives HDMI input including digital video and audio signals.
Carries both video and audio signals across a single cable.
(7) DVI-I terminal (P79)
Connects the external monitor output from a computer.
Receives digital PC signal (Digital PC).
A VGA-DVI-I cable can also be used to receive analog computer signals
(Analog PC-1).
(8) Analog PC-2 / COMPONENT terminal (P80)
Receives the analog PC signal (Analog PC-2).
A component cable can be used to receive the component image signal
(Component).
(9) Service port (P226)
Used to control the projector with user commands
(10) USB port (P56, P114, P135, P180)
Connects a USB flash drive. Used for projection of images on a USB flash
drive, or for firmware updates.
(3) (4)
(5) (6)
37
(8)
(7)
(10)
(9)
(P227 – P228).