Table of Contents
Advertisement
Terminals
6
Item
Label
1
TRIGGER
2
CONTROL
3
COMPUTER-2
4
COMPUTER-1
5
MONITOR-OUT
6
REMOTE
7
HDBaseT/LAN*
8
DVI-D
9
3G-SDI IN
10
3G-SDI OUT
11
HDMI
* Notes on HDBaseT
■
Use a shielded cable rated at CAT5e or higher.
■
Maximum transmission distance is 100 m.
However, maximum transmission distance may be shorter in some environments.
■
Do not use the LAN cable when it is coiled or bundled.
■
Inserting or removing the LAN cable during projection may cause noise.
■
Connectivity with all HDBaseT transmitters on the market is not guaranteed.
■
Some HDBaseT transmitters may not enable correct projection when used to connect source
equipment to the projector.
1
2
7
8
Provide 12V (+/- 1.5) output for screen operation.
Connect to the PC for system maintenance , projector maintenance
and user commands.
Receives the analog PC signal (Analog PC-2).
Connect BNC-type input connectors to the RGB or YPbPr/YCbCr
output signal video equipment.
Receives the analog PC signal.
Connect the D-sub 15pin input connector to the RGB output signal.
Outputs an analog RGB signal (COMPUTER-1) to display an
image on an external monitor.
This terminal is used to connect the optional remote control using a
cable. Connect a 3.5 mm jack from a wired remote.
Receives HDBaseT input including digital video and audio signals.
A LAN cable (shielded twisted pair of CAT5e or higher) can be
used for video input.
Connects the LAN cable. Used to connect the projector to a
network. However, the sound does not come out of the projector.
Receives digital PC signal (with DVI-D digital PC).
Receives SDI signal.
Outputs a signal connected with SDI IN terminal.
Receives digital video signals (HDMI).
20
3
4
9
10
Description
5
11
Advertisement
Table of Contents
