Canon WUX7000Z User Manual page 129

Menu Configuration
Information (P197)
Menu
Model name
Input signal
Firmware
Serial no.
Projector usage time
IP address (wired)
IP address (wireless)
Projector name
Comments
System information ID
*: Factory default, or state after [Factory defaults] is
executed.
The following settings are not reset
even when factory defaults are
restored.
• Selected input signal
• [Image adjustment]
- Save profile
- Baseline image mode
- Fine-Tune Gamma (saved value)
• [Install settings]
- Lens - Position
- High altitude
- Lens shift mode
- Marginal focus (setting value)
- Registration
- Operating mode
• [System settings]
- Remote control channel
- Extron XTP
- Serial communication (Stop bit)
- Standby power setting
- Language
- Date and time settings
- Schedule
- Gamma restore
- Air filter counter
- Power counter
- Firmware
• [Network settings]
• [Information]
129