Related Manuals for Barmesa Pumps 2SEV512
Summary of Contents for Barmesa Pumps 2SEV512
- Page 1 Installation, Operation & Maintenance Manual Submersible Sewage Pumps 2SEV512 0.5 @ 3500 RPM barmesapumps.com IMPORTANT! - Read all instructions in this manual before operating or servicing a pump.
-
Page 2: General Safety Information
IMPORTANT! - Barmesa Pumps is not installations where there is responsible for losses, injury or IMPORTANT! - Prior to installation, human contact with pumped fluid. -
Page 3: Specifications And Dimensions
Additional cord, slide rail coupling (SRC-2). barmesapumps.com CORD CORD LOCKED WEIGHT MODEL PART No. HP VOLTS PHASE (Nominal) AMPS ROTOR AMPS SIZE TYPE (pounds) 2SEV512 62180405 3500 10.2 16/3 SJTOW 2SEV512A 62180406 3500 10.2 16/3 SJTOW 2SEV512VF 62180407 3500 10.2... -
Page 4: Receiving And Installation
Receiving & Installation Receiving inspection Liquid Level Control Upon receiving the pump, it should Typical Discharge Pipe Mounted: inspected damage Refer to Figure 2 below which shows shortages. If damage has occurred, a typical installation of a 1 phase 115 file a claim immediately with the volt pump using a level control company that delivered the pump. -
Page 5: Installation & Service
Installation & Service Both a check valve and a shut-off This means that overload Plate 3. Name Record valve are recommended for each protector will trip out and shut the information from the pump name pump. The check valve is used to pump off if the windings become too plate to drawing in front of prevent backflow into the sump. - Page 6 Service With a flashlight, visually inspect the Apply pipe thread compound to 7. Remove screws and washers and oil in the housing to make sure it is threads of pipe plug then assemble lift motor housing and stator from clean and clear, light amber in color to housing.
- Page 7 Service Reassembly Power Cord: IMPORTANT! - All parts 8. Check power cord for cracks or must clean before damage and replace if required. reassembly. Handle seal Reconnect motor leads. parts with extreme care. DO NOT damage lapped surfaces. 9. Place power cord with nylon housing, ring, washer and gland nut into housing and tighten gland nut Bearings:...
-
Page 8: Repair Parts
Repair Parts 2SEV512 barmesapumps.com For Repair Part Please supply: Model Number and Serial as shown on Name Plate, and Part Description and Part Number as shown on Parts List. -
Page 9: Parts List
Parts List 2SEV512 ITEM DESCRIPTION QTY. MATERIAL Cable assembly 20 ft Pump body HT200 Capacitor 30uf/300V 90 °C Plastic Pin Capacitance clip Cross recessed pan head screw M4x10 Q235A Ground lead Upper bearing plate ZL102 Temperature protector 17AM032-05 Stator 10 Rotor... -
Page 10: Troubleshooting Chart
13. Piping attachments to building structure too loose or rigid NOTE: Barmesa Pumps assumes no responsibility for damage or injury due to disassembly in the field. Disassembly of the pumps or supplied accessories other than at Barmesa Pumps or its authorized service centers, automatically voids warranty.
Need help?
Do you have a question about the 2SEV512 and is the answer not in the manual?
Questions and answers