Coverage Patterns - wattstopper PW-100 Installation Instructions Manual

Alerts
The PW can provide audible and/or visible alerts as a warning before the load
turns OFF.
Visible Alert
(DIP #6 ON)
No Visible Alerts
(DIP #6 OFF)
Audible Alerts
(DIP #7 ON)
No Audible Alerts
(DIP #7 OFF)

COVERAGE PATTERNS

Coverage testing has been
performed according to the
NEMA WD 7 guideline. For best
performance, use in spaces not
larger than 15' x 12'.
PIR Sensor
The sensor has a two-tiered,
multi-cell viewing Fresnel lens with
180 degree field of view. The red
LED on the sensor flashes when the
PIR detects motion.
Masking the lens
Opaque adhesive tape is supplied
so that sections of the PIR sensor's
view can be masked. This allows
you to eliminate coverage in
unwanted areas. Since masking
removes bands of coverage,
remember to take this into
account when troubleshooting
coverage problems.
Call 800.879.8585 for Technical Support
When only one minute is left in the time delay, the
load connected to the relay turns OFF for one second.
This provides a one minute warning before the load(s)
are turned OFF by the sensor.
No visible warnings provided.
Unit will beep at one minute*, at 30 seconds and at 10
seconds before turning OFF load. When Walk-Through
is active, the unit beeps three times at 10 seconds
before the load goes OFF.
*If Visible Alert is also ON, the one-minute time-out
warning beep is replaced by the visible alert.
No audible warnings provided.
Top View
Major motion
Minor motion
PIR
Coverage
35'
(10.6m)
(6.1m)
Side View
4'
(1.2m)
0
20'
(2.2m)
15'
(4.5m)
7.5'
20'
(6.1m)
35'
(10.6m)