Initializing The Pgm1 - Yamaha PGM1 Installation Manual

Initializing the PGM1

If you want to return (initialize) the unit to its factory-set state, for example because the installa-
tion location has changed, proceed as follows.
1.
Power-off the PSE.
2.
On the rear panel, set device settings
DIP switch 7 to the downward posi-
tion, and set switch 8 to the upward
(INT.) position.
1 2 3 4 5 6 7 8
3.
Power-on the PSE.
Initialization begins.
• Initialization in progress:
All zone indicators flash rapidly.
• Initialization completed:
All zone indicators flash slowly.
• Initialization failed:
The status indicator flashes slowly.
NOTICE
Do not power-off the PSE while initializa-
tion is in progress. Doing so will cause
malfunctions.
4.
Verify that initialization is completed,
and then power-off the PSE.
5.
Set device settings DIP switches 7
and 8 both to the upward (RESUME)
position.
7 8
6.
Power-on the PSE.
The unit starts up in the factory-set
state.
7 8
PGM1/PGX1 Installation Manual 13