Bottom Panel - Yamaha PGM1 Installation Manual

• Switches 7–8 (START UP MODE)
Specify how the unit is initialized after
the power turns on.
Switch
7 8
Setting RESUME
This is the normal operating
mode.
When the PGM1's power is
Content turned on, it starts up while
preserving the state in which it
was immediately prior to pow-
ering-off.
Switch
7 8
Setting INT. (INITIALIZE)
The unit is initialized to the fac-
Content
tory settings (page 13).
e Dante/NETWORK connector
This is an RJ-45 port for connecting a
Dante device such as the MRX7-D using
an Ethernet cable (CAT5e or better) via
PSE.
NOTE
• Do not connect anything other than a Dante-
enabled device or a device that supports
gigabit Ethernet (including computers).
• The maximum cable length that can be
used is 100 meters.
• Use STP (Shielded Twisted Pair) cable to
prevent electromagnetic interference.
r SYNC indicator
This indicator shows the operating status
of the Dante network.
When the green indicator is lit, this indi-
cates that the unit is the clock slave and
that the clock is synchronized.
When the green indicator is flashing, this
indicates that the unit is the clock master.
t LINK/ACT indicator
This indicator shows the communication
status of the Dante/NETWORK connector.
If the Ethernet cable is connected cor-
rectly, the indicator flashes rapidly.
Controls and Connectors (PGM1)

Bottom Panel

q
q 8-pin dedicated connector
This is a dedicated connector for connec-
tion to the PGX1.
When the unit is shipped from the factory,
a rubber cap is attached here.
PGM1/PGX1 Installation Manual 11