2. Pulse Remote Control Unit
Image 2-6
2. Connect a cable with XLR plug into the XLR connector of the RCU.
3. Connect the other end of the cable with the XLR input of the projector.
2.7
Using the mini-jack connector of the RCU
Connecting a cable with the mini-jack connector will reset the broadcast address of the RCU to its default
value '0'.
How to use the mini-jack connector
1. Connect a cable with the mini-jack connector (reference 2 image 2-7) of the RCU.
2. Connect the other end of the cable with the mini-jack input of the projector.
Image 2-7
2.8
Silicone protection sleeve for the RCU (optional)
Introduction
Barco offers a silicone form fitting protection sleeve for the Pulse RCU. The silicone material keeps it comfortably, non slip and soft
touch. All buttons and holes remain accessible. The sleeve is quick and easy installed. For ordering information see Barco website.
How to install
1. Pull off the rubber XLR-lid from the RCU.
Image 2-8
16
2
R5906151 XDL 17/04/2018