Table of Contents
Advertisement
3.4
Communication connections
Communication Panel
1
2
3
Image 3-7
WIFI antenna for wireless IP (optional)
1
12V 1A output
2
Firmware update / USB download log files
3
4
10/100 base-T for external control over IP and Art-Net
DMX interface input
5
DMX interface output
6
XLR input for wired projector control
7
12 V output
12 V output, maximum 1 A, available when projector is not in stand by.
DMX interface
DMX is used as communication bus between different devices in the light technic. Each device has an input and an output, so that
the bus can be looped between the different devices. According the standard a five wire cable with XLR connector is used.
You can use the DMX input port to connect a DMX device (DMX console) to the projector. This way you can control the projector
from that DMX device (console). The DMX output port can be connected with the next device in the loop.
Pin
1
2
3
4
5
DMX
DMX-512 Lighting protocol over RS-485 interface. Carries information of 512 channels from a lighting controller to
lighting devices. Standardized by USITT.
RS232/RS422 input
The communication interface of the XDL series projector supports RS232 and RS422 serial communication on two different types
of input connectors, a Sub-D connector and an USB connector acting as RS input when connected to an USB input of a PC.
R5906151 XDL 17/04/2018
Active 3D
4 column mode (4x1 layout)
Passive
Standard layout (1x1 layout)
stereo
Passive
2 column mode (2x1 layout)
stereo
4
5
Description
Earth
Cold
Hot
Return - (or not used)
Return + (or not used)
•
960 x 2160 @120 Hz
•
960 x 2400 @120 Hz
•
1024 x 2160 @120 Hz
3840 x 2160 @60 Hz
1920 x 2160 @60 Hz
6
7
8
RS232 for serial communication
Sync Out 3D
9
10 Sync In 3D
Status lights
11
12 IR receive sensor
13 GSM antenna input (optional)
3. Input & Communication
8
9
10
11
12
13
25
Advertisement
Table of Contents
