Image - Barco XDL-4K75 User Manual

Image 2-5

2.4 Functions of the "button pressed indicator"
Functions button pressed indicator
• Rapidly flashes when commands are sent, this is the normal "button pressed" indication.
• 1 Short flash when remote control is switched ON by means of the on/off button.
• Continuously lit (up to 5 seconds) when address digits are expected after pressing the ADDR button.
• Slowly flashes (2 times a second) when the battery level is becoming low; typically when more than 85% of the useful life is
past.
2.5 Displaying and Programming addresses into the RCU
Displaying the Projector Address on the Screen.
1. If the projector is on, press the menu key and navigate to the Status page. The projector address and the broadcast address can
be seen under the Communication heading.
The projector's address is displayed on the LCD status screen and / or the OSD.
How to Program an Address into the RCU?
1. Press the Address button until the Button pressed indicator lights up continuously (proximately 5 seconds).
2. Enter the address with the digit buttons within the time the indicator lights up (also proximately 5 seconds).
Note: That address can be any value between 0 and 31.
Tip: A few examples:
To enter address 3, press "3" digit button on the RCU to set the RCU's address to 3 and wait until the button pressed
indicator is out. Alternatively, you can also press "0" and "3". This way, the button pressed indicator goes out immediately.
To enter address 31, then press "3" and "1" on the digit button on the RCU and the button pressed indicator goes out
immediately.
2.6 Using the XLR connector of the RCU
Connecting a cable with the XLR connector will reset the broadcast address of the RCU to its default value '0'.
How to use the XLR connector
1. Remove the XLR cover by pulling it backwards.
R5906151 XDL 17/04/2018
1
2. Pulse Remote Control Unit
15