How To Select - Barco XDL-4K75 User Manual

6. GUI – SOURCE
About the Source menu
This menu is used to select, review and configure sources into the projector.
Overview of features
• Displaying a single source
• Displaying multiple sources: Stitched layouts
• Connector Settings
6.1 Displaying a single source
About selecting a source
Before a source can be projected, the source signal must be connected to the source input(s) of the device and a valid synchroniza-
tion signal must be available along with the source signal on at least one of the input connectors.

How to select?

1. Press Menu to activate the menus and select Source.
Image 6-1
Select Source
2. Press OK.
The Select Source menu is displayed with the actual available sources filled out.
3. Select the desired input.
6.2 Displaying multiple sources: Stitched layouts
About stitched layouts
The first time you use a selected single source, the source will be displayed in the projector's native resolution. If the resolution of
the source is different to the projector's resolution, the image is stretched or shrunk.
It is however possible to configure and display two or four source signals to make up one single image in full native resolution. This
is called a Stitched Layout: the sources are stitched together.
The following table lists which stitched layouts you can use, and in which display mode these layouts can be used.
The table below describes the different Stitch Layouts and scan directions.
Type of layout
1
: Single
R5906151 XDL 17/04/2018
Description
A single source is displayed in full
screen
Available connectors
Quad Combo input:
• SDI (4x)
• HDBaseT (2x)
• DisplayPort
• HDMI
Quad DP 1.2 Input:
• DisplayPort (4x)
6. GUI – Source
Mode
Mono / Active stereo
43