KT&C KPT-SPDN300 Installation Manual

KA-ICM
Installation Guide for KPT-SPDN300
1
1. Install three (3) support and screw (M4x10) assemblies
through the holes in the upper position of 'Shield Cover'.
2. After assembling supporter(L45) to the support bracket,
secure the screws(M4x10) on to the camera.
2
1. Secure the eyebolts (M6)
to prevent falling of the
in-ceiling Housing body.
2. Use three (3 ) screws
(M3X8, flat head type) to
secure the eyebolt.
3
Ø7.87
1. Cut a hole in the ceiling
to use a Mounting Guide
in the Package by Ø7.87 and
insert the in-ceiling housing.
2. Using screwdriver, tighten
the three (3) screws clockwise.
4
Fasten the top cover by turning it to the diretion
of CLOSE.
5
Unit: inch
To prevent from falling, secure the Safety wire
using screws or eyebolt.