Table of Contents
Advertisement
Mounting the switch in the rack
This task requires two people.
To mount the switch in the rack:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Verify that the mounting brackets and chassis rails have been securely attached to the switch
chassis.
3.
Verify that the slide rails have been correctly attached to the rear rack posts.
4.
Attach cage nuts (user-supplied) to the front rack posts and make sure they are at the same
level as the slide rails.
5.
One person performs the following tasks:
a. Supporting the bottom of the switch, aligns the chassis rails with the slide rails on the rack
posts.
b. Pushes the switch slowly to slide the chassis rails along the slide rails until the mounting
brackets are flush with the rack posts.
6.
Another person uses screws (user-supplied) to attach the mounting brackets to the rack.
To secure the switch in the rack, make sure the front ends of the slide rails reach out of the
chassis rails.
Figure 11 Mounting the switch in the rack (power supply-side mounting position for the
mounting brackets)
12
Advertisement
Table of Contents
