Procedure - Agilent Technologies E4406A User Manual

Procedure

1. If the auto alignment for the UUT has not been run within the last
hour, run it by pressing
2. Preset the UUT by pressing
3. Initialize the parameters for the instrument, as listed in Table 5-15,
"UUT Initialization," by performing the following steps:
a. Press , and
MODE
b. To expand the Spectrum window to full screen, ensure that the
Spectrum window is highlighted and press
If the Spectrum window is not highlighted, press
until the Spectrum window is highlighted and then press
c. Press ,
Marker Trace
d. Press
FREQUENCY
e. Press ,
SPAN Span
f. Press ,
Input Input Atten
g. Press
Meas Setup
until (2 of 2) is displayed, and
h. Press
Meas Setup
,
ADC Range Manual
i. Press
Meas Setup
, until Off is underlined.
Pre-ADC BPF
j. Press
Meas Setup
k. Press
Meas Setup
l. Press
View/Trace, Trace Display
Chapter 5
,
System Alignment
.
Preset
.
Basic
, .
Spectrum Avg
, , 600, and
Center Freq
, 800, and .
Hz
, 10, and .
dB
, until (2 of 2) is displayed,
More
ADC Dither
, until (2 of 2) is displayed,
More
−6 dB
, and .
, until (2 of 2) is displayed,
More
, ,
Average Avg Number
, , , and
Average Avg Type
, and
Average
Functional Testing
Phase Noise
, and .
Align All Now
.
Zoom
Next Window
Zoom
.
MHz
,
Advanced
until On is underlined.
,
Advanced
, and
Advanced
, 5, and .
Enter
.
Pwr Avg (RMS)
.
.
More
165