Operation - Wassermann WAPO-Ex Service Manual

6 Operation

6.1 Operation
1. Turn on main switch (green rocker switch).
2. The red water-level LED (10) should not come on or flash. If it does, check the water
level or the water-level sensor.
3. Choose Polymerisation or Scalding.
4. Place prepared caps in unit.
5. Set desired time and temperature for scalding (see 6.2.1).
6. Set desired time and temperature for polymerisation (see 6.2.2).
7. Use Start/Stop (7) to start the program.
8. The yellow LED (9) comes on during heating.
9. After the set time, the unit switches off automatically and a tone sounds.
Note: Each button has a built-in red LED. Start the program once the
Polymerisation
Scalding
Time
Temperature
Heater
10
Low water level
desired temperature has been reached.
1
2
3
6
9
- 7 -
8
Digital display
4
Set / Plus
5
Default / Minus
7
Start/ Stop