6.2.5 Setting the temperature
1. Press and hold Temperature (6), then press
Start/Stop (7) once. The first character on the
display (8) flashes to indicate that the value
can be changed by pressing Set-Point (4) or
True Value (5) while Temperature (6) is held
on. Release all three buttons to store the
changed value.
2. The value is stored by simultaneously
pressing Polymerisation (1) and Set-Point
(4).
3. For the second value, press and hold
Temperature (6), then press Start/Stop (7)
once. The second character on the display
flashes. Follow the same sequence as
above.
All instructions for using the unit, whether verbal, written or in the
form of practical guidance, are based on individual experience and
experimentation and can only be regarded as guidelines.
- 10 -
4. The procedure is the same for the third
display character. Each change needs to be
stored.
5. If Temperature (6) is pressed and held, and
Start/Stop (7) pressed a fourth time, the first
of the three individual temperatures is
displayed.
1
8
5
4
6
7