Polymerisation (Choice Of 3 Times And 3 Temperatures); Setting The Time - Wassermann WAPO-Ex Service Manual

6.2.3 Polymerisation (choice of 3 times and 3 temperatures)

The Polymerisation (1) and Set-Point (4) LEDs must be on, but not Start/Stop (7). Use
the buttons as described below to set the function. This allows you to check and/or
change stored values.

6.2.4 Setting the time

1
8
3
4
- 9 -
1. Press and hold Time (3), then press Start/Stop (7) once.
The first character on the display (8) flashes to indicate
that the value can be changed by pressing Set-Point (4)
or True Value (5) while Time (3) is held on. Release all
three buttons to store the changed value.
2. Store the value by simultaneously pressing
Polymerisation (1) and Set-Point (4).
5
3. For the second value, press and hold Time (3) again,
then press Start/Stop (7) once. The second character
on the display flashes. Follow the same sequence as
above.
7
4. The procedure is the same for the third display
character. Each change needs to be stored.
5. If Time (3) is pressed and held, and Start/Stop (7)
pressed a fourth time, the total of the three individual
times is displayed.
Times assigned the value zero (0) are ignored.