Figure 3.1. Sample Programs On Fd; Table 3.1. Data Format - Contec COM-2(PCI) User Manual

Support software
CONTEC does not provide driver software for MS-DOS or
Windows 3.1. If using the boards on MS-DOS, refer to the sample
programs in the DOS directory of the supplied FD.
Sample programs for MS-DOS
The sample programs for using the board under MS-DOS are
written in Microsoft C.
The attached FD contains following sample programs.

Table 3.1. Data Format

Parameter
(ii) (iii) (iv) (vii) (viii)
Baud rate
Data bits
Stop bits
Parity
DOS --- Samples ---
(i)
(ii) COMPCI01.C
(iii) COMPCI02.C
(iv) COMPCI03.C
(v)
(vi) COMPCI05.C
(vii) COMPCI06.C
(viii) COMPCI07.C

Figure 3.1. Sample Programs on FD

COM-2(PCI), COM-4(PCI), COM-8(PCI)
Data format
(v) (vi)
9600bps 230.4Kbps
8 bits
2 bits
None
COMPCI.C Resource check program
COMPCI.EXE
Data transmission
COMPCI01.EXE
Data reception
COMPCI02.EXE
Interrupt-driven data reception
COMPCI03.EXE
COMPCI04.C Data transmission and reception
COMPCI04.EXE
Interrupt-driven data transmission
COMPCI05.EXE and reception
Half-duplex data transmission
COMPCI06.EXE
Half-duplex data reception
COMPCI07.EXE
Board Setup
33