For Windows 95 Systems - Contec COM-2(PCI) User Manual

For Windows 95 Systems

Every PCI bus board/device will be automatically assigned required
system resources, such as I/O address range and interrupt level, by
the system whenever the system is turned on.
Under Windows 95 OS, before using the board you should register
the board information, such as assigned resources, to the OS. This
procedure is called hardware installation. After the hardware
installation is done, Windows 95 can then manage the board
information from its registers.
Following is hardware installation steps. After finished the
installation, you are supposed to confirm the registered board
information from Windows 95 registers.
This procedure does not install board driver(s). Lately you should
install driver program(s) yourself.
Hardware Installation Steps
<Checking the OS version>
The procedure of installing the board is different from the
Windows 95 versions. Before any installation, you must check the
version of Windows 95 that you are using.
(1) Open [Control Panel] from [My Computer].
(2) Double-click on the [System] option to open the [System
(3) Check the "System:" number displayed on the [General] page.
The versions of Windows 95 include 4.00.950, 4.00.950a,
4.00.950B and 4.00.950C. The board setup method depends on
the version of Windows 95 that is being used.
Properties] property sheet.
System : Microsoft Windows 95
4.00.950
COM-2(PCI), COM-4(PCI), COM-8(PCI)
Board Setup
19