ProSoft Technology RLX2-IHA User Manual page 73

RLX2-IHx series ♦ 802.11a, b, g, n
Industrial Hotspots
Parameter
Repeater
Bridging Client
Client
Auto / Specify
(Client mode only)
Client MAC
ProSoft Technology, Inc.
October 30, 2017
Description
Specifies that this radio is a Repeater radio. Repeater mode is the
normal mode for the radios in the network that are not the Master radio.
The Master radio specifies the network channel and is the root of the
radio network tree. Repeater radios extend the range of a network and
create the signal bridges that allow networked radios to communicate
over a greater distance. All RLX2-IHx series radios are capable of being
Repeaters. See Configuring a Repeater Radio (page 48).
Specifies a special mode for use where there are multiple Ethernet
devices that need to connect to any 3
Access Points (AP). This mode uses a Layer 2 Network Address
Translation mechanism, and can only work for IP-based protocols. If
using non-IP-based protocols, then specify Client mode for this radio.
See Configuring a Bridging Client Radio (page 50).
This is a special mode that allows you to transparently connect a single
Ethernet device to any non-ProSoft 802.11 a, b, g, or n Access Point
(AP). To the AP, the MAC address of the Ethernet device would appear
to be an 802.11 wireless client. Client mode supports all network
protocols. See Configuring a Client Radio (page 53).
Choose S only if the device does not send out any unsolicited
PECIFY
Ethernet packets. Try A
UTO
Specify the MAC ID of the device connected to this radio, only if the
device does not advertise its MAC address.
Configuring a Radio - Detailed Configuration
rd
-party 802.11 a, b, g, or n
first.
User Manual
Page 73 of 227