Operating Modes - MTX -4G-JAVA-IoT Hardware User's Manual

7.2 Operating modes

The table below briefly summarizes the MTX-3G-Java operating modes referred to in the next chapters.
LIMITS FUNCTION
Normal GSM/GPRS/UMTS/
operation HSPA SLEEP
GSM/GPRS/
UMTS/HSPA IDLE
GSM TALK/GSM
DATA
GPRS DATA
EGPRS DATA
UMTS TALK/UMTS
DATA
HSPA DATA
Low Power Available in "L" option devices. All the electronics systems remain disconnected
mode from the power supply input, with the exception of RS232/RS485 interfaces and
its controller. This allows to wake up the unit from those interfaces.
Ultra Low Available in "U" option devices. All the electronic systems remain disconnected
Power mode from the power supply input, with the exception of a little piece of logic which
allows for waking up the unit again from a tamper input or after a specified time.
Airplane Airplane mode shuts down the radio, causes the modem to log off from the
mode GSM/GPRS network, and disables all AT commands whose execution requires
radio connection. Airplane mode can be controlled by AT command.
MTX-Java-IoT | 2018/2
MTX © by MATRIX ELECTRONICA S.L.U.
SUPPORT: iotsupport@mtxm2m.com | SALES: info@mtxm2m.com |
Power saving automatically activated when no calls
are in progress, the USB connection is suspended
by the host or not present, and there is no active
communication via ASC0.
Power saving is disabled if a USB connection is not
suspended, but no call is in progress.
Connection between 2 subscribers in progress. Power
consumption depends on the GSM network coverage
and several connection settings (e.g. DTX off/on, FR/
EFR/HR, hopping sequences and antenna connection).
The following applies when power is to be measured in
TALK_GSM mode: DTX off, FR and no frequency hopping.
GPRS data transfer in progress. Power consumption
depends on network settings (e.g. power control level),
uplink/downlink data rates and GPRS configuration (e.g.
used multislot settings).
EGPRS data transfer in progress. Power consumption
depends on network settings (e.g. power control level),
uplink/downlink data rates and EGPRS configuration
(e.g. used multislot settings).
UMTS data transfer in progress. Power consumption
depends on network settings and data transfer rate.
HSPA DATA
mtxm2m.com
21