Certificates And Approvals; Ce Mark; Ex Approvals; Pressure Equipment Directive (Ped) - Endress+Hauser Cerabar T PMC131 Technical Information

Cerabar T

CE mark

Ex approvals

Pressure Equipment Directive
(PED)

Functional safety SIL 2

Suitability for hygenic
processes

TSE Certificate of Suitability

Standards and guidelines

Registered trademarks

Endress+Hauser

Certificates and approvals

The device meets the legal requirements of the EC directives. Endress+Hauser confirms that the device has
been successfully tested by applying the CE mark.
All explosion protection data are given in separate documentation which is available upon request. The Ex
documentation is supplied as standard with all devices approved for use in explosion hazardous areas.
→ See also Page 22, "Safety Instructions" section.
This measuring device corresponds to Article 3 (3) of the EC directive 97/23/EC (Pressure Equipment
Directive) and has been designed and manufactured according to good engineering practice.
The Cerabar T PMP131 and PMP135 pressure transducers with 4 to 20 mA electronics have been assessed by
an independent body according to the standards IEC 61508/IEC 61511-1. These devices can be used for
monitoring process pressure up to SIL 2.
→ For a detailed description of safety functions with Cerabar T, settings and characteristic quantities for
functional safety, see the "Functional Safety Manual – Cerabar T SD160P".
The Cerabar T PMP135 is suitable for the employment in hygenic
processes.
An overview of permitted process connections on page 14.
Many versions meet the requirements of 3A-Sanitary Standard No. 74
and are certified by the EHEDG.
!
Note!
The gap-free connections can be cleaned without residue using the
usual cleaning methods.
Cerabar T PMP135
The following applies to wetted device components: They do not contain any materials derived from animals.
No auxiliaries or operating materials derived from animals are used in production or processing. Process wetted
device components are listed in the "Mechanical construction" and "Ordering information" sections.
DIN EN 60770 (IEC 60770):
Transmitters for controlling in systems used in industrial process technology
Part 1: Methods for evaluating the operating behavior.
DIN EN 61003-1, Edition:1993-12
Systems used in industrial process technology;
Devices with analog inputs and two-point or multi-point behavior;
Part 1: Methods for evaluating the operating behavior.
DIN 16086:
Electrical pressure measuring devices, pressure sensors, transmitters, pressure measuring devices
Terms, specifications in data sheets.
IEC 60592
Degrees of protection provided by enclosures (IP-Code).
EN 61326:
Electrical equipment for control technology and laboratory application – EMC requirements.
IEC 61010
Safety requirements for electrical equipment for measurement, control and laboratory use.
NAMUR
Association for Standards for Control and Regulation in the Chemical Industry.
®
Ceraphire
Registered trademark of Endress+Hauser GmbH+Co. KG, Maulburg, Germany
(→ see also www.endress.com/ceraphire)
TYPE EL
October 2007
74 - 74 -
17