Blaupunkt New Jersey MP68 Operating And Installation Instructions page 117

Use the rocker switch
u
the setting "12 HR – AM", "12 HR – PM" or
"24 HR MODE".
Press the rocker switch @ to switch on
u
the selected setting.
Press the OK button : to select a different
u
function, or press the DIS•ESC button ; to
exit the menu.
Setting the time (CLK SET)
In the System menu, press the rocker switch
u
@ repeatedly until the "CLK SET"
or
menu item is selected.
Press the OK button : to call up the menu
u
item.
The time is displayed.
Select the hours or minutes with the rocker
u
switch or @.
Enter the desired digit by pressing the
u
corresponding button of the keys A.
After entering the complete time,
press the OK button : to store the time
u
entered.
Note:
To fi nish the entry without changing the
time, press the DIS•ESC button ;.
Changing volume presettings
The following presettings can be changed in the
System menu:
• Power-on volume (ON VOL / LAST VOL)
•
Volume presettings of traffi c announcement
(TA VOL), telephone/navigation announce-
ment (TEL VOL) and volume reduction
(MUTE VOL)
•
Signal tone (BEEP ON)
•
Speed-dependent volume increase
(AUTO SND)
@ to select
or
Adjusting power-on volume (ON VOL /LAST
VOL )
To adjust the power-on volume,
in the System menu, press the rocker switch
u
@ repeatedly until the "ON VOL"
or
menu item is selected.
Press the OK button : to call up the menu
u
item.
The current power-on volume is displayed.
Set the power-on volume with the rocker
u
switch or @.
Press the OK button : to select a different
u
function, or press the DIS•ESC button ; to
exit the menu.
You can also select the setting "LAST VOL". This
sets the volume at power-on to the volume at the
last switch-off:
In the System menu, press the rocker switch
u
@ repeatedly until the "LAST VOL"
or
menu item is selected.
Press the OK button : to call up the menu
u
item.
Switch between the settings with the rocker
u
switch or @.
•
"LAST VOL"
•
"LAST VOL"
Press the OK button : to select a different
u
function, or press the DIS•ESC button ; to
exit the menu.
Note:
If "LAST VOL" is switched off, the device is
switched on with the volume adjusted under
"ON VOL".
Changing volume presettings for TA, TEL and
MUTE
If the device switches a traffi c announcement,
phone call or navigation announcement, it
always starts with the volume preset here.
User settings
: On.
: Off.
117