Copyrights And Registered Copyrights; Troubleshooting - Casio Oceanus OCW-G2000S-1A Operation Manual

Stopping Radio Wave Emission by This
●
Watch
The watch is emitting radio waves whenever
the second hand is pointing to "C".
Even if the second hand is not pointing at "C",
the watch will automatically attempt to
connect with a phone four times a day to adjust
its time settings.
When in a hospital, on an aircraft, or in any
other area where the use of radio waves is not
allowed, use the operations below to stop
radio wave generation.
Stopping Radio Wave Generation
●
Press (C) to terminate the Bluetooth
connection.
Connected After disconnection
Disabling Auto Time Adjustment
●
Configure OCEANUS Connected settings
to disable synchronization between the
watch and phone.
Using the Watch in a Medical Facility or
l
Aircraft
Copyrights and Registered
Copyrights
Bluetooth ® is a registered trademark of
●
Bluetooth SIG, Inc.
iPhone and App Store are registered
●
trademarks of Apple Inc. in the United
States and other countries.
iOS is a trademark or registered trademark
●
of Cisco Systems, Inc.
GALAXY, GALAXY Note, and GALAXY S
●
are registered trademarks of Samsung
Electronics Co., Ltd.
Android and Google Play TM are registered
●
trademarks of Google Inc.
Other company names and product names
●
used herein are trademarks or registered
trademarks of their respective companies.
Operation Guide 5501

Troubleshooting

Signal Reception (GPS)
Q1
The watch cannot perform a receive
operation.
Is the watch's battery charged?
Signal reception is not possible while
battery power is low. Keep the watch
exposed to light until it recharges
sufficiently.
Solar Charging
l
Is the watch in the Timekeeping Mode?
Signal reception is not possible unless the
watch is in the Stopwatch Mode. Note that
signal reception is also disabled in the
Airplane Mode. Return to the
Timekeeping Mode and/or exit the
Airplane Mode.
Navigating Between Modes
l
After checking the above, the watch still
cannot perform a receive operation.
GPS signal reception is not possible
under the conditions described below.
During power saving
●
While the crown is pulled out
●
Q2
The second hand remains at "T+P" or
"T(TIME)" during the signal receive
operation.
The watch may be receiving leap second
information.
Leap Second Reception
l
Q3
The signal receive operation always
fails.
Is the watch in a location that is appropriate
for signal reception?
Check your surroundings and move the
watch to a location where signal reception
is better.
Appropriate Signal Reception Location
l
Is the face of the watch pointed straight
upwards at the sky?
Minimize movement of the watch while the
receive operation is in progress.
When the watch is set up for auto receive,
take care to avoid covering the watch face
with the sleeve of your clothing.
Q4
Signal reception should have been
successful, but the watch's time and/
or day is wrong.
Is your Home City setting correct for your
location?
Change your Home City setting so it
correctly reflects your location.
Acquiring GPS Position Information
l
Manually
Setting a Home Time City
l
Is the hand and/or day indicator alignment
correct?
Adjust hand and/or day indicator
alignment.
Adjusting Hand and Day Indicator
l
Alignment
After checking the above, the time and/or
day settings is still wrong.
Adjust time and day settings manually.
18