5. Operation
5.1. Overview
5.1
Overview
Display modes
The transmitter has the following display modes.
Test. Appears briefly after power-up to self-test the display.
Connection status. Appears when transmitter is not fully connected to the OneWireless network. See
section 5.2.
PV display. Default mode of the transmitter displays the PV and any status messages. See section 5.3
on page 18.
Quick view of transmitter identification parameters. Displays read-only parameters then returns to PV
display. See section 5.4 on page 21.
Menu. See section 5.5 on page 22.
Authentication Device
To navigate the transmitter displays and menus, hold the Authentication Device no more than 6" from the
transmitter and aim the infrared beam at the transmitter display while tapping the Device Local
Configuration buttons (Table 10). You can also use the PDA's buttons.
Authentication Device menus are described in section 5.6 starting on page 23.
16
5. Operation
OneWireless XYR 6000 HLAI Transmitter R120 User's Manual
Revision 9
July 2011