10-5 Comparator Function
The comparison of comparators can select 3-steps or 5-steps (Cp fnc, Cp-t), and it is set to 3-steps at the
factory setting.
When 3-step comparator is set, the results of the comparison are indicated by HI
display.
When 5-step comparator is set, HH is indicated by HI blinking and LL by LO blinking.
By using GXA-04, it is possible to output the comparison result at the contact point.
There are three types of scope that can be selected as follows.
No comparison
Comparison when the weight data is stable or overloaded
Continuous comparison
The conditions for comparing near zero are in six levels from "including near zero" to "± 100 digits".
"Upper limit value and lower limit value" and "reference value and tolerance range" are the
comparison standards.
"Digital input" and "Input by sample load" are the for each value input methods for each value.
Refer to the function setting
By setting the function setting
the result of the comparison.
3-step comparison result
Weighing value
Threshold value
Upper limit value
Upper limit
Lower limit value ≦
Lower limit
5-step comparison result
Weighing value
Threshold value
2nd
Upper limit value
Second upper limit
Upper limit value
Upper limit
Lower limit value ≦
Lower limit
2nd
Lower limit value
Second lower limit
Note
□ In the flow measurement, the comparator function is used with the total weight.
Cp fnc
.
Cp beep ,
Judgment formura
< Weighing value
Weighing value
≦
Judgment formura
<
Weighing value
Weighing value
<
Weighing value
Weighing value
≦
Weighing value
it is also possible to sound an internal buzzer depending on
3-step comparison - display
Judgment
result
HI
OK
Upper limit value
LO
5-step comparison - display
Judgment
result
HH
2nd
HI
≦
Upper limit value
≦
Upper limit value
OK
LO
<
Lower limit value
2nd
<
LL
Lower limit value
52
OK
Blinking
Lit display
display
HI
OK
LO
Blinking
Lit display
display
HI
HI
OK
LO
LO
LO on the
Buzzer
control
Buzzer
control